Fairbanks 5001 Series QuickSilver IS Bedienungsanleitung

Operating ManualQuickSilver IS5001 Series50770Revision 5 04/12© 2012 by Fairbanks Scales Inc.All rights reserved

Section 4: Security50770 10 04/12 Rev. 5A. Security LevelsThe QuickSilver IS is shipped with the least protected security level, 00, programmed int

Section 5: Operation50770 11 04/12 Rev. 5A. KeysON - When pressed, turns the indicator ON. The display will go through awarm- up sequence and then

B. Indicators:NET When ON, indicates the scale is in the NET mode. When OFF, indicates the scale is in the GROSS mode.lb Indicates the scale is using

The equation, NET = GROSS -TARE, is particularly important because it is the equation that a scale uses to figure net weights in NET WEIGHING MODE. T

Note: In the Checkweighing Mode the ZERO, AUTO/TARE, and UNITS keys are disabled.50770 14 04/12 Rev. 5d. Weighing UnitsTo select the desired weighin

A. Accept Range DisplayB. Under Range DisplayC. Over Range Display(Target Value -Limit Value)(Target Value -2 x Limit Value)(Target Value +2 x Limit V

50770 16 04/12 Rev. 55. With the appropriate TARGET weight displayed, press the same OVER/UNDER key, 1, 2, 3, or 4 as was pressed in Step 2. 6. To c

Section 6: Battery Pack* * WARNING! * *Battery packs are to be charged in non-hazardous areas only!INPUT VOLTAGES 120 VAC, 60 HzBATTERY OUTPUT VOLTAG

C. States of OperationSTATE 1: NO BATTERY• RED LED is constantly on.• No battery is attached to the charger, and no current is flowing from the ch

50770 19 04/12 Rev. 5Appendix I: FM CONTROL DRAWINGS

50770 20 04/12 Rev. 5

50770 21 04/12 Rev. 5

50770 22 04/12 Rev. 5

50770 23 04/12 Rev. 5

50770 24 04/12 Rev. 5

50770 25 04/12 Rev. 5

Amendment RecordQuickSilver IS 5001 Series50770Manufactured by Fairbanks Scales Inc.821 Locust StreetKansas City, Missouri 64106Issue 1 10/2004 New

Table of ContentsSection 1: IntroductionA. Introduction ……………………...…………..… 5Section 2: DescriptionA. Serial Tag Model Legends...

Section 1: Introduction50770 5 04/12 Rev. 5The 5001 Series of bench scales and indicators have stainless steel construction. They aredesigned for

Section 2: Description50770 6 04/12 Rev. 5A. Serial Tag Model Legends:P=PlatformP=Pillar (2nd "P")I=Indicator or IND = Indicator OnlyW=Wa

50770 7 04/12 Rev. 5NTEP Appv’d LB KG OZ GYES 30.00 X .01 13.610 X .005 480.0 X .2 13610 X 5YES 30.00 X .02 13.61 X .01 480.0 X .5 13610 X 10YES 30.

2. Rounding: Nearest division (0.5 division rounded upwards)3. Overload Protection: 500% of scale capacity. On 18” x 24” and 24” x 24”models - 300%.

A. Mounting:Mounting the QuickSilver IS Instrument with wall mounting bracket :1. Choose a location within the length of the cable between the indicat